MTM Stainless Steel 3/8" Pressure Washer Hose Reel | 50'
These Hose reels are hot water rated up 215°F and boast anti corrosion components with a high performance stainless swivel. Hardware is not included for mounting as this is specific to your mounting requirements
Simply slide the swivel end of your Kobrajet hose through the opening provided at the side of the reel core and install the 3/8" Male NPT threads into the 3/8" Female NPT threads of the swivel. Do not make a Quick Coupling joint at the swivel as there is not enough space and the bend in the line is too severe. Be sure to allow a small amount of slack at the swivel joint and use the red hose fastener provided to secure the hose at this joint.
Using a whip line connected to your pump, connect to the 3/8" Male NPT hose reel inlet. When planning, add an extra foot to the distance of the whip line so as not to bend the whip line too severely. Lastly, install the handle with the hardware provided.
Before leaving your hose reel unattended, always engage the locking mechanism on the side of the reel.
These are entry level hose reels, they are a great product for the price but take a little bit of work and some other parts to set them up properly. Here is how we suggest setting these up:
The outlet for your high pressure hose is on the side and is 3/8" female. Our Kobrajet hoses with bare 3/8" male ends will connect here, we do not suggest using quick connects for this connection point.
We do HIGHLY RECCOMEND you get one of these elbow to make this connection easier:
The inlet is on the back of the reel and 3/8" Male. We suggest installing one of these plugs on it:
This is where you would connect one of our jumper hoses from your pressure washer to the reel, in the length that works best for you.
You can find them here: Jumper Hoses/Whip Lines
We suggest installing these 3/8" coupler on both ends of your jumper hose:
The last piece you would need is a quick connect plug for the outlet of your pressure washer, we have these available in M22 14 and 15 sizes.